How To Measure Body Piercing Jewelry
Whether you are a professional piercer trying to determine what size jewelry you need to carry or may already have in your shop or you are an end consumer with piercings, it is crucial to be able to understand how body jewelry is measured. Proper measurements will ensure that you have the right size jewelry on hand for any piercing.
Gauge
On quality body jewelry, you should find a measurement indicating the diameter of the wire itself that the jewelry is made from. This number can be anything from 20g-2” and sometimes, even larger. The “g” in the measurement refers to the gauge. Because body piercing jewelry is milled from wire, it is measured like wire–in gauges. The higher the number of the gauge, the smaller the diameter or thickness of the wire. For example, the size of the wire on a regular earring is usually 20g. The thickness of a belly ring, however, is 14g–a thicker wire. The gauge measurement goes all the way to 00g, and then the measurements for wire are indicated in either millimeters or inches. For instance a large plug may be anywhere between 7/16”-2” or beyond.
Length
The next measurement you’ll need to know is the length of the piece of jewelry.
Straight Barbell, Labret
On a straight piece of jewelry, the length is the measurement of the length of the shaft between the two ends. That means that to measure the length, you should measure the length in between the inside of the two ends–NOT the outside of the ends. See diagram below.
Segment ring, Captive Bead Ring
On a round piece of jewelry, the “length” is measured as the diameter of the piece, from inside wire edge to inside wire edge across the widest area of the circle. See diagram below.
Curved Barbell
A curved barbell is measured in a straight line from the inside edge of each end or ball (essentially the straight distance across the curved from inside one ball to the inside of the other).
Wearable surface
The wearable surface is the measurement you’ll need if you are shopping for plugs or tunnels. It indicates the width of the tube from inside flare to inside flare on a plug or tunnel. It is the space upon which your ear will sit or spread when the plug is in your piercing. It is NOT the diameter of the plug or tunnel, which is measured as above. You’ll want your wearable surface to accommodate the thickness of your ear just right. If the wearable surface is too large, your jewelry will slide around and can even fall out. If it is too narrow, it can chafe and make the jewelry uncomfortable and even cause your piercing to become irritated.
Threading
Threading is measured like the threads on screws. If your body jewelry is threaded, meaning the end screws into or onto the shaft, it has a “thread pattern”. A thread pattern refers to the geometry and spacing of the screw thread. If you look closely at your jewelry, you will note that there are ridges that come to points and in between each ridge is a small space. This space is called the pitch in metric measures, or the threads per inch (TPI) in imperial measurements. In addition to the measurement of the spaces, the thread pattern can also refer to the type of threading a piece of jewelry has–either internal or external. Thread pattern in terms of spacing is rarely indicated on packaging at a consumer level, but any good manufacturer of body jewelry should be able to tell you their thread pattern. It is especially important for piercers who buy from multiple manufacturers. The threading may not be the same pattern from supplier to supplier, and different threads will make heads and shafts incompatible.